| 1.
Pulse output function
1) A special controller is not necessary
since pulse is directly output from the FP-M. This economic
system enables a positioning control.
2) FP-M has two pulse outputs, so it can be
connected directly to the drivers which have two pulse
inputs.
3) Pulse output frequency can be selected
among the 6 ranges.(1,440 Hz to 5 kHz/720 Hz to 5 kHz/360 Hz
to 5 kHz/180 Hz to 5 kHz/90 Hz to 5 kHz/45 Hz to 5 kHz)
-
-
|
|
|
| 2.
Interrupt input function
1) This function enables high-speed
processing at a fixed timing and is not affected by scan
time
2) It is useful when performing control
which would be disrupted by variations in processing time
due to such factors as timing synchronization.
-
|
|
|
| 3.
High-speed counter function
1) This function can be applied to the
digital on inverter control using encoder input.
2) This function supports four modes:
· Two-phase input, UP, DOWN, and UP/DOWN.
3) Counting up to 10 kHz is possible in the
2 phase input
-
|
|
|
| 4.
Using RS232C port (for C type only)
Using RS232C port enables such serial
communication with RS232C equipment such as reading data
from bar code reader and interactive data exchange with
image checker.
-
|
|
|
| 5.
Clock/Calendar function (for C type only)
1) The control data can be changed by year,
month, day, hour, minute, second and day of the week.
2) This function can be used for automatic
startup of a machine and equipment and recording of
operating condition.
-
|
|
|
6. I/O
power supply for easy wiring of I/O circuit (when using C20T,
C32T, M1T-E, M1T-EI, M1T-EO)
-
1) Merit 1
Without Power Supply
Since power supply (24 V DC) is supplied to
the input connector, the input devices can be connected
without power supply.
-
2) Merit 2
Use Power for Sensor
The 24 V DC power supply on the input
connector can be used as a power supply for photoelectric
sensor.
-
3) Merit 3
Use Power for Light Loards
When the load current is low by using LED
load, the 24 V DC power supply of the output connector can
be used.
-
|
|
|
