|
FP3 Features
1. The FP3 is designed in mind the
expandability of both hardware and software
The 16-, 32- or 64-point I/O unit easily
expands without any limitation on the number and position of
units.
By adding up to 2 boards (from 48 up to 512
points), the number of I/O's can be increased up to 1536
points.
2. A wide range of units are available to
meet your specific control needs.
Analog I/O units (7 types)
High-speed counter position control units (4
types)
Operation display panel, computer I/F unit
(1 type)
Serial data control units (2 types)
Remote I/O units (3 types)
Linking units (5 types)
3. A series of CPU units with comment
memory is also available.
I/O comments can be written in the CPU unit
for circuit verification to facilitate the review and change
of the program. *
* For part number AFP3211C only
4. ROM (Optional)
ROM is available for program storage and
copy memory.
FP10SH Features
1. High-speed scanning speed of 1 ms/10k
step
Its parallel processing system executes
computation and communication processing by separate micro
processors respectively, to provide high-speed computation
and communication processing.
2. Ample program capacity
A RAM with 30k steps is standard. Memory can
be expanded up to 60k/120k steps by adding an expansion
memory.
3. The FP10SH supports the 115k bits/s
communication port.
Both the tool port and the standard RC232C
port support 115k bits/s, allowing high-speed communication
when a program is transported or an operation display panel
is connected.
4. ROM/IC memory card is optionally
available
ROM/IC memory cards can be installed in the
unit for program storage and copying.
Comment memory installed on optional boards
allows you to write the comment on a generated program in
the CPU.
The IC memory card can also be used as
expansion data memory.
5. Instructions for high-speed processing
and data processing are added.
Timer instructions in 1 ms and real number
operation instructions are added.
|
Features
